Member Since: 26 Apr 2014
Location: Leamington Spa
Looking for some help with the Altox app.
My heater only stops alight (smoke seen)for approx 3 minutes before I get error 5 .
Looked at the diagnosis on the app and I can see the heater temp rise then after about 2 mins the flame sensor changes from no to yes then after about 3 mins flame sensor changes back to no.
So questions are-
1) when lit and working ok should the flame sensor say yes or no
2) Do you think a strip down an clean would cure the error 5.
Error 5 description-
Flame was detected prior to combustion1) The reason for the air intake pipe or exhaust gases. 2) The reason for the fuel system. 3) Check the pump dispenser. 4) Check the electrical system pin filament.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum