Member Since: 23 Mar 2009
Location: Hertfordshire
Posts: 348
Auto headlight problem
It seems to be taking longer for the headlights to automatically turn on, they normally come on just as I go into the Hatfield tunnel on the A1, and off just after exiting (as you'd expect), and the same on the two tunnels along the M25 between the A10 and the M11..........but they don't come on straight away, and then they don't turn off
Is something failed/failing, or can I reset something ?
Thanks,
JimJim
Standard TDV6 HSE
Non-standard Td5 110 Hardtop
Club Traxide
23rd Jun 2010 11:51 am
bambi
Member Since: 10 Apr 2009
Location: south yorkshire
Posts: 2059
Wash the sensor area of the windscreen?
23rd Jun 2010 3:40 pm
JimboD3
Member Since: 23 Mar 2009
Location: Hertfordshire
Posts: 348
bambi wrote:
Wash the sensor area of the windscreen?
, for once, the whole vehicle is quite clean !Jim
Standard TDV6 HSE
Non-standard Td5 110 Hardtop
Club Traxide
23rd Jun 2010 3:42 pm
The Transformer
Member Since: 22 Jan 2010
Location: Leicestershire
Posts: 1791
They do seem to do odd things, ours had a weekend of bringing the lights on on bright sunshine (clean screen) has been fine since.
23rd Jun 2010 5:26 pm
philhunt
Member Since: 16 Sep 2007
Location: MI5 not 9 to 5
Posts: 1761
Mine switch themselves off as they should the 1st time after they've come on automatically. The next time they come on (in the next tunnel for example) they stay on until I turn the switch back to manual from automatic.
The dealer's looked at the problem half a dozen times in the last 3 years and has never been able to resolve it. I've given up using the automatic setting now.Clubs Mantec, Tasmods, LEDS, AT2s on 18s, Maxxis Bighorns on 17s, Remote FBH, BAS. ReMap, BSS., RLD Personalised SWP., Safari Snorkel, Faultmate, Three Musketeers & MUD
23rd Jun 2010 9:24 pm
DiscoDunc
Member Since: 08 May 2006
Location: Bristol
Posts: 16390
even though the window may seem clean - the grease residue can effect the operation.
clear the window with meths....Duncan
-----------------------------------------------------
If I'd known I was going to be so thirsty this morning I'd have drunk more beer last night.
FFRR Autobiography 4.4 SDV8 MY17
D4 HSE MY13 SOLD
FFRR 3.6 Vogue TDV8 SOLD
D4 HSE MY10 SOLD
D4 SE TECH MY15 SOLD
D4 XS MY12 SOLD
D4 HSE MY10 SOLD
D3 HSE MY06 - Re-Cycled Worldwide
23rd Jun 2010 10:05 pm
blue meanie D3 Decade
Member Since: 04 Aug 2005
Location: Newbury
Posts: 6861
a couple of years ago in a similar post DG wrote:
The sensor is only acting on ambient lighting conditions ..it may be that the angle of the sun was higher or lower in the sky or the sunlight was coming in from a different direction. I wouldn't worry too much TBH
GTR wrote:
The automatic headlamp function is a driver assistance system. The driver can override the system operation by selection of side lamp or headlamp on if the ambient light conditions require front and rear lighting to be active. The automatic headlamp system uses a light sensor and the CJB, which are connected via the LIN bus to control the headlamp functionality.
A light sensor is incorporated in the rain/light sensor located on the inside of the windshield, below the rear view mirror. The wiper system also uses the rain/light sensor for automatic wiper operation.
The light sensor measures the ambient light around the vehicle in a vertical direction and also the angular light level from the front of the vehicle. The rain/light sensor uses vehicle speed signals, wiper switch position and the park position of the front wipers to control the system.
The automatic headlamp operation uses ambient light levels which are monitored by photodiode incorporated in the rain/light sensor. The rain/light sensor sends a lights on/off request to the CJB on the LIN bus, which responds by switching on the low beam headlamps, front side lamps and rear tail lamps.
The automatic headlamps are activated under the following conditions:
Twilight
Darkness
Rain
Snow
Tunnels
Underground or multistoried car parks.
Operation of the automatic headlamps requires the ignition switch to be in position II, the lighting control switch to be in the 'AUTO' position and a lights on request signal from the light sensor.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum