Advertise on DISCO4.COM
Forum · Gallery · Wiki · Shop · Sponsors
DISCO4.COM > Technical (D3)

Best route for wire ?
Post Reply  Down to end
Page 1 of 1
SGH
 


Member Since: 21 Dec 2009
Location: Hellingly. East Sussex.
Posts: 1178

United Kingdom 2015 Discovery 4 3.0 SDV6 HSE Lux Auto Montalcino RedDiscovery 4
Best route for wire ?

Planning on running feed from my Optima Yellow top directly back to the back to power a socket for my Engel fridge.

I have a couple of questions that someone here might be able to help with with....

1. I am wanting to run wires down the drivers side of vehicle are there any ideal holes in bulkhead to access engine bay this side ?
2. How does the panel below steering column come off ?

Simon
 Defender 300Tdi 110 HCP - Keswick Green
Discovery 4 SDV6 HSE LUX - Montalcino Red/Black Pack - Gone
Connect L2 Double Cab - Moondust Silver
Connect L1 - Moondust Silver
VW California Ocean 150PS DSG - Reflex Silver 
 
Post #63545713th Apr 2010 7:10 pm
View user's profile Send private message View poster's gallery Send e-mail Reply with quote
MacLeod 313
 


Member Since: 18 Apr 2008
Location: away
Posts: 10723

Scotland 2006 Discovery 3 TDV6 HSE Auto Zambezi SilverDiscovery 3

I beleive there is a REDUNDANT grommit near the Servo in the bulkhead simon, as your is a Auto it will be un-used, and is where TFC passed the loom for my Spotlights. The best panel ( the Easiest) to remove is the one with the Headlight controls fitted and is also where TFC fitted the spot switch.

My guessing is thats both the locations to start with Thumbs Up
  
Post #63547013th Apr 2010 7:22 pm
View user's profile Send private message View poster's gallery Reply with quote
Bodsy
Site Sponsor 


Member Since: 06 Nov 2006
Location: In the Clubhouse
Posts: 21361

United Kingdom 2007 Discovery 3 TDV6 HSE Auto Java BlackDiscovery 3

Can't see if your an auto or not. If auto, there is a hole you can use to the right of the brake servo. Cable then comes through easil and can be fed along and under the plastic cover to the right of the drivers seat. Easy peasy. Thumbs Up
 Bodsys Brake Bible

D4/D3 Remote FBH heat kits
BAS Remaps/ EGR Blank
Transmission Flush
Software updates/enabling


Clock/ SNOTM /3Flash / 4x4Info /BT Update /Service Reset/Error Codes / Gearbox Reset
See It Here 
 
Post #63547113th Apr 2010 7:24 pm
View user's profile Send private message View poster's gallery Send e-mail Reply with quote
discoBizz
 


Member Since: 20 Sep 2008
Location: Manchester
Posts: 1416

United Kingdom 2008 Discovery 3 TDV6 HSE Auto Tonga GreenDiscovery 3

These may be of help regarding the grommet in question:

Click image to enlarge

Click image to enlarge


Feeding of the wire under the trim is fiddlier than one may think, be careful not to loose the metal clips Whistle


Good luck Thumbs Up
  
Post #63548213th Apr 2010 7:33 pm
View user's profile Send private message View poster's gallery Send e-mail Reply with quote
MacLeod 313
 


Member Since: 18 Apr 2008
Location: away
Posts: 10723

Scotland 2006 Discovery 3 TDV6 HSE Auto Zambezi SilverDiscovery 3

Thats the Kiddie Thumbs Up
  
Post #63548413th Apr 2010 7:35 pm
View user's profile Send private message View poster's gallery Reply with quote
SGH
 


Member Since: 21 Dec 2009
Location: Hellingly. East Sussex.
Posts: 1178

United Kingdom 2015 Discovery 4 3.0 SDV6 HSE Lux Auto Montalcino RedDiscovery 4

That great.

I'll be having a look tmorrow.
 Defender 300Tdi 110 HCP - Keswick Green
Discovery 4 SDV6 HSE LUX - Montalcino Red/Black Pack - Gone
Connect L2 Double Cab - Moondust Silver
Connect L1 - Moondust Silver
VW California Ocean 150PS DSG - Reflex Silver 
 
Post #63551513th Apr 2010 8:18 pm
View user's profile Send private message View poster's gallery Send e-mail Reply with quote
simoniz
 


Member Since: 28 Oct 2007
Location: The green green grass of home!!!!!
Posts: 3755

Wales 2005 Discovery 3 TDV6 Base 7 Seat Manual Buckingham BlueDiscovery 3

To remove panel under steering wheel pull with two hands on upper edge and voila it will come down - held in by two spring clips which might go awol when you try to pull panel down particularly if its never been off before since leaving the factory. Bottom edge has two tabs which locate to the dash surround and act as a hinge once you release the top edge.

Thumbs Up
  
Post #63552313th Apr 2010 8:34 pm
View user's profile Send private message View poster's gallery Reply with quote
discoBizz
 


Member Since: 20 Sep 2008
Location: Manchester
Posts: 1416

United Kingdom 2008 Discovery 3 TDV6 HSE Auto Tonga GreenDiscovery 3

...and for the lower panel, undo the two philips screws, pull the left kickpanel out towards the footwell, then let the panel drop slowly (gently pulling towards the seat), and unclip the footwell light connector Thumbs Up

This should give you good access to the area where the wire will come through from where that grommet is located in the engine bay (you'll need to use a screwdriver or knife to cut a hole in the insulation behind the grommet - this is done from the engine bay side)
  
Post #63553413th Apr 2010 8:49 pm
View user's profile Send private message View poster's gallery Send e-mail Post Reply
Display posts from the last:  
Post Reply Back to top
Page 1 of 1
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO4.COM Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums

DISCO4.COM is independent and not affiliated to Land Rover.
Switch to Mobile Site