Member Since: 22 Dec 2009
Location: Maidstone
Posts: 7274
Morepower wrote:
Do you need any speacial tools to change this top bush, and does the car need 4 wheel alignment after? I’ve got one with a bit of play in it (MOT advisory) and I thought I’d change it before it gets too bad👍🏻
I just measured from the centre of the bolt head to a fixed easy to get to point on the upper arm, not saying its right?
I bought a universal bush puller from ebay, but theres a post on here someshere where (bodsy?) used a small hydraulic puller.
Its not hard to do at all and if it wasnt for faffing about with the loose bush I reckon easy under an hour for a first timer.
22nd Oct 2018 7:02 am
gstuart
Member Since: 21 Oct 2016
Location: kent
Posts: 13613
Hi mate
I used my digi pas digital angle finder to set my rear off side camber up after i replaced the upper wishbone and bolt
Got it within 2 degrees, enclosed my alignment sheet , think it was pot luck
Have u seen the other camber tool , pic below
22nd Oct 2018 8:24 am
lynalldiscovery
Member Since: 22 Dec 2009
Location: Maidstone
Posts: 7274
Bit of an update, bush lasted 5 years, centre punch dimples and loctite still keeping it tight in the knuckle.
So this time new better quality bush, centre punch and loctite again, and off we go for another round.
23rd Aug 2023 3:21 pm
darrind
Member Since: 04 Jul 2008
Location: In A World of My Own!
Posts: 2863
Fingers Crossed!Must stop buying shiny toys....
23rd Aug 2023 4:50 pm
M3DPO
Member Since: 22 Sep 2010
Location: Notts.
Posts: 8073
lynalldiscovery wrote:
Bit of an update, bush lasted 5 years, centre punch dimples and loctite still keeping it tight in the knuckle.
So this time new better quality bush, centre punch and loctite again, and off we go for another round.
Look on the bright side, bet it came out easy once you’d broke the Loctite seal. It can when others can't,
It will when others won't,
It goes where others don't.
23rd Aug 2023 5:37 pm
lynalldiscovery
Member Since: 22 Dec 2009
Location: Maidstone
Posts: 7274
To be honest the puller made light work of it, in and out.
6th Sep 2023 6:27 pm
Sidestick
Member Since: 22 Apr 2012
Location: Rome
Posts: 2288
gstuart wrote:
Hi
Ur need a puller to get it out and yes will need 4 x wheel alignment done after
I got this kit and made the job very easy
Do you have any link to buy this kit?- Easy-Lift suspension module 4.0
- GoodWinch 9500 lb
- Full underbody protections
- Tree/Rock sidebars
- Prospeed roofrack & ladder
- Compressor guard
- Raised Air Intake
- Driving lights (2+4)
- 50 mm Waffle boards
- Altox Heater control
- Overland Rooftop Tent
- Rear seats entertainment
- Front & Rear camera
- GVIF
- Removable tow bar
- Cubby box fridge
- BFG KO2 265/65R17
- iidTool BT
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum