Member Since: 20 May 2015
Location: Peterborough
Posts: 2
Dog gate fitting -D4 HSE
Hi Folks.
I have recently taken delivery of a 10 plate Disco 4 HSE to replace my trusty (written off) D2. I have a Barjo dog gate ready to fit inside the tailgate, but haven't a clue where the electrics run in the rear pillars where I need to drill the fixing holes (approx 6 inches from the top). Any tips or guidance? I swore by my Haynes manual for the D2 and previous Freelander, but don't think there is such a beast for the D4! :
3rd Jun 2015 11:43 pm
Streffie
Member Since: 30 Mar 2014
Location: Midlands
Posts: 171
Bite the bullet, and grab yourself the genuine one, it's very good, no drilling, uses original bolt holes
11th Jun 2015 9:16 pm
discoteca
Member Since: 08 Mar 2010
Location: Warwickshire
Posts: 1477
I wouldn't be drilling a D4 to fit a dog gate. Get one of these instead. Takes less than a minute to fit or remove no drilling or fixings required.
Click image to enlarge
11th Jun 2015 10:36 pm
RandomKamikaze
Member Since: 10 Dec 2014
Location: Berkshire
Posts: 448
Where is that from please?Disco gone
12th Jun 2015 10:23 pm
discoteca
Member Since: 08 Mar 2010
Location: Warwickshire
Posts: 1477
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum