Advertise on DISCO4.COM
Forum · Gallery · Wiki · Shop · Sponsors
  Home · FAQ · New Posts · My Posts · PMs · Search · Members · Members Map · Groups · Profile · Donate · Register · Log In  
DISCO4.COM > Technical (D3)

Help!
Post Reply  Down to end
Page 1 of 1
fob
 


Member Since: 28 Mar 2008
Location: Wigan
Posts: 48

United Kingdom 2005 Discovery 3 TDV6 Base 7 Seat Manual Zambezi SilverDiscovery 3
Help!

Trying to run a cable from glove box to rear of car spent ages looking doesnt seem anywhere obvious anyone any ideas? would be a massive help! Thumbs Up  
Post #44273423rd Mar 2009 12:09 pm
View user's profile Send private message View poster's gallery Reply with quote
Gareth
Site Moderator 


Member Since: 07 Dec 2004
Location: Bramhall
Posts: 26702

United Kingdom 

Either up the A pillar, and along the edge of the headlining, or remove the door threshold trim and push under carpet.  
Post #44273723rd Mar 2009 12:11 pm
View user's profile Send private message View poster's gallery Reply with quote
fob
 


Member Since: 28 Mar 2008
Location: Wigan
Posts: 48

United Kingdom 2005 Discovery 3 TDV6 Base 7 Seat Manual Zambezi SilverDiscovery 3

Cheers gareth will go out to the car again and have another look Bow down  
Post #44274323rd Mar 2009 12:15 pm
View user's profile Send private message View poster's gallery Reply with quote
Bodsy
Site Sponsor 


Member Since: 06 Nov 2006
Location: In the Clubhouse
Posts: 21361

United Kingdom 2007 Discovery 3 TDV6 HSE Auto Java BlackDiscovery 3

you can lift the trim that goes along the doors (front and rear) be careful of the 'spring clips' as you may lose some, but there is a channel underneath it that can be easily used. Is it a large cable?

As you get to the rear seats, it will then just slip underneath the plastic and into the boot (Passenger side may have the air con system in the rear) but plenty of room for some cables. Thumbs Up Bodsys Brake Bible

D4/D3 Remote FBH heat kits
BAS Remaps/ EGR Blank
Transmission Flush
Software updates/enabling

Clock/ SNOTM /3Flash / 4x4Info /BT Update /Service Reset/Error Codes / Gearbox Reset
See It Here  
Post #44274723rd Mar 2009 12:19 pm
View user's profile Send private message View poster's gallery Send e-mail Reply with quote
SN
 


Member Since: 03 Jan 2006
Location: Romiley
Posts: 13710

all good advice thanks - I had the freeview box running in the car yesterday afternoon and found signal was useless unless I plonked aerial on roof - I think I've going to sort out a clamp onto the very rear of the roof rail for it and feed coax back through the car Steve N | 21MY Defender | 08MY Discovery 3 (history) | 06MY Discovery 3 (ancient history)   
Post #44274823rd Mar 2009 12:21 pm
View user's profile Send private message View poster's gallery Send e-mail Reply with quote
Bodsy
Site Sponsor 


Member Since: 06 Nov 2006
Location: In the Clubhouse
Posts: 21361

United Kingdom 2007 Discovery 3 TDV6 HSE Auto Java BlackDiscovery 3

Plenty of space for the coax Steve. I have twin 50amp cable running to the back (driver side) (8 guage....?? Confused ) Bodsys Brake Bible

D4/D3 Remote FBH heat kits
BAS Remaps/ EGR Blank
Transmission Flush
Software updates/enabling

Clock/ SNOTM /3Flash / 4x4Info /BT Update /Service Reset/Error Codes / Gearbox Reset
See It Here  
Post #44275123rd Mar 2009 12:22 pm
View user's profile Send private message View poster's gallery Send e-mail Reply with quote
fob
 


Member Since: 28 Mar 2008
Location: Wigan
Posts: 48

United Kingdom 2005 Discovery 3 TDV6 Base 7 Seat Manual Zambezi SilverDiscovery 3

It's a network cable so i can wire the rear strobes hopefully Mr. Green  
Post #44276123rd Mar 2009 12:31 pm
View user's profile Send private message View poster's gallery Reply with quote
Bodsy
Site Sponsor 


Member Since: 06 Nov 2006
Location: In the Clubhouse
Posts: 21361

United Kingdom 2007 Discovery 3 TDV6 HSE Auto Java BlackDiscovery 3

Ah yeah, easy peasy. That's what I plan to do also (already have that for my on off on switch to the LF 170 relay (wired, but not yet fitted.....) Bodsys Brake Bible

D4/D3 Remote FBH heat kits
BAS Remaps/ EGR Blank
Transmission Flush
Software updates/enabling

Clock/ SNOTM /3Flash / 4x4Info /BT Update /Service Reset/Error Codes / Gearbox Reset
See It Here  
Post #44277023rd Mar 2009 12:41 pm
View user's profile Send private message View poster's gallery Send e-mail Post Reply
Display posts from the last:  
Post Reply Back to top
Page 1 of 1
Jump to:  
< Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO4.COM Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums
DISCO4.COM is independent and not affiliated to Land Rover.
Switch to Mobile Site