beetroot
Member Since: 21 Mar 2017
Location: Waikato
Posts: 11
|
Missing Technical Specs (torque setting, ring gap etc) |
|
Hi all,
I joined a few years back and have lurked a lot, but the time has almost come for me to buy a Disco 3.
There is a super dooper cheap D3 local to me with a few engine issues (TDV6), I've been doing lots of research and found a repair manual but it appears to be missing some critical data.
The maintenance procedures like ring gaps, piston measurements, crankshaft end float, bearing cap torque etc, all say too compare against the 'specifications' but then doesn't give any, theres a list of torque specs at the start of each chapter, but it doesn't give them all.
Anyone else come across this?
I've used Rave a heap for my D1 and D2 and never had any issues, but some tech specs for these newer LRs seem to be hard to come across.
Cheers
|
12th Aug 2019 4:59 am |
|
|
Discologist
Member Since: 19 May 2014
Location: Yorkshire
Posts: 537
|
I noticed on a Saturday but was to lazy to do anything about it. I had to resort to Google.
|
12th Aug 2019 5:59 am |
|
|