ajsms999
Member Since: 28 Jul 2009
Location: shropshire
Posts: 206
  
|
| Restraints Control Module reconfigure |
|
Heres one for all the Faultmate Gurus 
My vehicle is a October 2012 SDV6 commercial.
I have just installed both the front and rear curtain airbags which are ommitted on the commercial.
My MSV 2 Extreme allows me to read & clear all faults, and my CCF is arranged correctly, infact it reads 'undefined' in all areas relating to the curtains.
However when I next cycle the ignition, after a 5 second delay, the amber airbag light illuminates and records the following fault codes:
B0021, B0029, B0022 & B002A - all are described as 'signal plausibilty failure'.
All the wiring and connections are present and correct.
On searching Topix the solution is to reconfigure the Restraints Control Module - this apparantly is something my dealer can do with his diagnostic tool, although I haven't yet asked.
Can I do this with my MSV2?
If so how?
Alternatively, if I buy a new RCM will this be configured to suit?
Any help is greatly appreciated. 
Regards
Andrew
|
 20th Nov 2012 8:19 pm |
|
|
geoff.
Member Since: 24 Jan 2010
Location: West kent
Posts: 8531
|
Andrew
is it a single veh MSV2 you have 
im just wondering if its software in that ecu that can be updated to say a HSE
just had a quick look at Restraints control module and theres 27 files maybe one of those would work can you take a copy of the general settings and let me have a look i will compare it to a hse one
|
| 20th Nov 2012 8:37 pm |
|
|
ajsms999
Member Since: 28 Jul 2009
Location: shropshire
Posts: 206
|
Thanks Geoff,
My MSV 2 is a single vehicle.
I will try to copy the settings detail and will attempt email it to you.
Thanks for your immediate response
Andrew
|
| 20th Nov 2012 8:44 pm |
|
|
