Member Since: 08 May 2006
Location: Bristol
Posts: 16390
Rigid Dually D2s
Finally got round yesterday and today to start installing the DuallyD2s - 2 sets
copied Russell's idea of a bracket - but with 4 mounts not two.
Now I know my welding isnt quite upto RLD standards. After all, i did in sitting on the floor , whereas RLD would do it in situ travelling at 90mph down the M6, but a bit of a rub down and some paint and it'll look fine. its not going to come off, thats the main thing!!
so made a bracket : (its looks all bent but thas just the photo for some reason )
Click image to enlarge
then bolted it to the front of the carsh frame. I thought it would be a bit wobbly, but when all bolted up its rock solid
bolted through this rectangular hole by shamelessly copying Russell's idea
Click image to enlarge
attached light mounts. I was a little concerned about have four prongs protruding fromt the front of the car, but once they were cut to size they seemed OK and set back enough.
Click image to enlarge
Click image to enlarge
then mounted the lights but need to space them out evenly. They are not to everyones taste as they are a bit yellow.
Click image to enlarge
However, the objective is to have bright lights and not something that just looks blingy - and boy are they bright.
Meet the Bad Boys !!!
Click image to enlarge
as you can see I havnt wired them up yet - if anyone knows where I can get a feed from main beam please tell.
I cant find an M/B fuse and the wires going into the back of the light all seem to be live and none change voltage when m/b is switched on !!Duncan
-----------------------------------------------------
If I'd known I was going to be so thirsty this morning I'd have drunk more beer last night.
FFRR Autobiography 4.4 SDV8 MY17
D4 HSE MY13 SOLD
FFRR 3.6 Vogue TDV8 SOLD
D4 HSE MY10 SOLD
D4 SE TECH MY15 SOLD
D4 XS MY12 SOLD
D4 HSE MY10 SOLD
D3 HSE MY06 - Re-Cycled Worldwide
19th Aug 2012 4:45 pm
Ent
Member Since: 12 Oct 2007
Location: In the cack
Posts: 6485
Dunc
I would be tempted to take a feed direct from the battery via a relay triggered by your front fog lights. This way you don't have an extra switch to install in the cabin.Club Exped trailer
Club Timed Climate
Club Flappy paddle steering wheel
Club 300bhp
Club Prospeed test pilot/lab rat
Club National Luna Stella conditioner
IID Pro MV License - D3, D4 & RRS - Enabling, Updates, D4 & RRS Timed / Remote Climate, D4 Bluetooth fitting
PM me for details
Owner of the original "Beanie" grille
D4 & RRS style D3 grilles made to order
19th Aug 2012 8:19 pm
POINTYED
Member Since: 22 Mar 2008
Location: BURY,LANCS
Posts: 2758
would one of these fit the d3 the same way?
if so i think i will be commisioning dunc to make another at a cost of course
i like it alot and want one but welding is not my game
dunc life is tooooo short.enjoy the moment.dont worry be happy
club BSS
19th Aug 2012 8:27 pm
MHP
Member Since: 31 Dec 2011
Location: lydd
Posts: 2776
they look really good dunc were having the same problem with the wiring, but dad now has a very complicated wiring diagram but has not got round to looking t it! If you want i can get him to email it to you?
19th Aug 2012 8:41 pm
DiscoDunc
Member Since: 08 May 2006
Location: Bristol
Posts: 16390
Ent wrote:
Dunc
I would be tempted to take a feed direct from the battery via a relay triggered by your front fog lights. This way you don't have an extra switch to install in the cabin.
but i want them to come on with main beam !!! going to pop into Dealers tomorrow and see what they say..Duncan
-----------------------------------------------------
If I'd known I was going to be so thirsty this morning I'd have drunk more beer last night.
FFRR Autobiography 4.4 SDV8 MY17
D4 HSE MY13 SOLD
FFRR 3.6 Vogue TDV8 SOLD
D4 HSE MY10 SOLD
D4 SE TECH MY15 SOLD
D4 XS MY12 SOLD
D4 HSE MY10 SOLD
D3 HSE MY06 - Re-Cycled Worldwide
19th Aug 2012 9:38 pm
RichardB
Member Since: 04 May 2010
Location: Hants
Posts: 485
DiscoDunc
Very interested to understand how much these add to Xenon main beams. What focus beams do you have on those pairs?
Cheers
19th Aug 2012 10:27 pm
DiscoDunc
Member Since: 08 May 2006
Location: Bristol
Posts: 16390
still to test once wired up but the fugures show that they will deliver more light than the 4 x LF140s upto about 500 meters and a whiter light upto about 300m I think it wasDuncan
-----------------------------------------------------
If I'd known I was going to be so thirsty this morning I'd have drunk more beer last night.
FFRR Autobiography 4.4 SDV8 MY17
D4 HSE MY13 SOLD
FFRR 3.6 Vogue TDV8 SOLD
D4 HSE MY10 SOLD
D4 SE TECH MY15 SOLD
D4 XS MY12 SOLD
D4 HSE MY10 SOLD
D3 HSE MY06 - Re-Cycled Worldwide
19th Aug 2012 10:30 pm
Russell
Member Since: 24 Aug 2007
Location: Kent
Posts: 10564
Duncan if you get any where with the wiring please let me know so I can shamlessly copy as per the bracket MY17 D5 1st Edition Namib Orange
MY15 D4 HSE Kaikoura Stone
MY12 D4 HSE Nara Bronze Sold and gone
MY11 D4 HSE Stornaway Grey Sold and gone
D3 S spec Silver Sold and gone
Tow bar, full length roof bars, side steps, tow bar storage unit, surround camers.
D4 camera club
19th Aug 2012 11:07 pm
DiscoDunc
Member Since: 08 May 2006
Location: Bristol
Posts: 16390
will see what dealer says tomorrow and let you knowDuncan
-----------------------------------------------------
If I'd known I was going to be so thirsty this morning I'd have drunk more beer last night.
FFRR Autobiography 4.4 SDV8 MY17
D4 HSE MY13 SOLD
FFRR 3.6 Vogue TDV8 SOLD
D4 HSE MY10 SOLD
D4 SE TECH MY15 SOLD
D4 XS MY12 SOLD
D4 HSE MY10 SOLD
D3 HSE MY06 - Re-Cycled Worldwide
19th Aug 2012 11:09 pm
MikeS2005
Member Since: 13 Sep 2008
Location: Midlothian
Posts: 920
Duallys
Hi Dunc
Glad you are pleased with them can you send me some photos when its all finished including some night shots if you get a chance It would be appreciated
Dunc you wouldnt happen to have the old spotlight loom in your old car as Im looking at being able to replicate just the loom for resale
cheers
20th Aug 2012 12:09 pm
MHP
Member Since: 31 Dec 2011
Location: lydd
Posts: 2776
any luck with the wiring dunc?
20th Aug 2012 12:14 pm
DiscoDunc
Member Since: 08 May 2006
Location: Bristol
Posts: 16390
no yet, called into see dealer and they printed the wiring diagram - said somehting about "FeZ" ??? wiring, if thats how you spell it.
they havnt had any one ask for spots on the ne D4 yet !!!.
they are going to take a look at the wiring diagrams for me and see what needs to be done -but just taking a feed off the main beam circuit isnt going to work - something about resistance and lots of other stuff I didnt understand !!
they suggested may be switch the driving lights relay around and switch the earth - but they will look at it over the next few days and get back to me.Duncan
-----------------------------------------------------
If I'd known I was going to be so thirsty this morning I'd have drunk more beer last night.
FFRR Autobiography 4.4 SDV8 MY17
D4 HSE MY13 SOLD
FFRR 3.6 Vogue TDV8 SOLD
D4 HSE MY10 SOLD
D4 SE TECH MY15 SOLD
D4 XS MY12 SOLD
D4 HSE MY10 SOLD
D3 HSE MY06 - Re-Cycled Worldwide
20th Aug 2012 6:30 pm
MHP
Member Since: 31 Dec 2011
Location: lydd
Posts: 2776
ok.... im wondering if dad should go and see our dealer and see if they say anything diffrent!
20th Aug 2012 7:25 pm
DiscoDunc
Member Since: 08 May 2006
Location: Bristol
Posts: 16390
i wouldnt expect them too - all D4s are the same !!Duncan
-----------------------------------------------------
If I'd known I was going to be so thirsty this morning I'd have drunk more beer last night.
FFRR Autobiography 4.4 SDV8 MY17
D4 HSE MY13 SOLD
FFRR 3.6 Vogue TDV8 SOLD
D4 HSE MY10 SOLD
D4 SE TECH MY15 SOLD
D4 XS MY12 SOLD
D4 HSE MY10 SOLD
D3 HSE MY06 - Re-Cycled Worldwide
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
)
