Advertise on DISCO4.COM
Forum · Gallery · Wiki · Shop · Sponsors
DISCO4.COM > Tips & Tricks

Spare wheel removal...modification.
Post Reply  Down to end
Page 3 of 3 <123
wiggs
 


Member Since: 03 Sep 2006
Location: Manchester
Posts: 14368

United Kingdom 2015 Discovery 4 3.0 SDV6 HSE Auto Fuji WhiteDiscovery 4

Ok ..i finally got round to emptying my boot out.

I have amended the first post .

The lenght in total is 145MM.

If you dont have a deep 22mm socket then it will be slightly less ..140MM on mine

Thumbs Up
 G4 Gone ...but not forgotten  
Post #16246629th May 2007 3:44 pm
View user's profile Send private message View poster's gallery Reply with quote
caverD3
 


Member Since: 03 Jul 2006
Location: Oberon, NSW
Posts: 6922

Australia 2012 Discovery 4 3.0 SDV6 SE Auto Fuji WhiteDiscovery 4

Thought I should do something about the winder without removing the boot contents and lifting seats, now that I have Coopers and probably wont, get another pucture for while. Rolling Eyes

First thing I did was water proof the hole.
a short lenth of foam backing rod:

Click image to enlarge


This was glued end to end to make a doughnut, sealant put in hole and over rod then pushed under the lip of the hole:

Click image to enlarge



More sealant added:

Click image to enlarge


I tested if any water got in by aiming a hose above the tyre in every direction; no water ingress at all. Very Happy

Added a socket and adaptor for extension bar, held in place with some sealant:

Click image to enlarge


I found it difficult locating the extension bar onto the socket so I dremelled a slot into each plastic cover on the seats:

Click image to enlarge


Click image to enlarge


This makes a guide slot when the seats are folded flat:

Click image to enlarge


Put a small hole in the boot liner so all you need is a small wrench and extension bar:

Click image to enlarge


Just wind away! Very Happy

Click image to enlarge


If a draw system is installed it may be possible to leave a gap here and add a 90 degree drill adaptor and bring the bar horizontally out to the back. You may even be able to put a reverable drill in as part of the kit. Idea
 â€œThere are only three sports: bullfighting, motor racing, and mountaineering; all the rest are merely games”
Ernest Hemmingway
D4 3.0 Active Diff, Adaptive Lights, High Beam Assist, Surround Cameras, Privacy Glass.
D3 2.7:Adaptive Headlights,Electronic Rear Diff,ARB Bar,Blaupunkt Speakers,JVC Powered Subwoofer,Removable Snorkel,Mitch Hitch,Pioneer After Market Head Unit,Steering Wheel Control Adaptor,Remote Adjustable Supension Rod System, Taxside Dual Battery System. 
 
Post #22283310th Nov 2007 6:34 am
View user's profile Send private message View poster's gallery Reply with quote
dick dastardly
 


Member Since: 29 May 2007
Location: wiggleigh bottom
Posts: 1112

Switzerland 2008 Discovery 3 TDV6 SE Auto Stornoway GreyDiscovery 3

Under extreme conditions, mud/water above lower tailgate line e.g when climbing steeply out of a mud bath, you WILL get ingress into the car that would normally be stopped by the rubber bung. Only noticed all the mud under the bung when testing out wheel changing for the first time after off roading in deep water / mud.
 There's one wheel on my wagon, but i'm still rollin' along, it's the cherokee, they're after me, but I'm singing a happy song  
Post #23431615th Dec 2007 1:31 am
View user's profile Send private message View poster's gallery Post Reply
Display posts from the last:  
Post Reply Back to top
Page 3 of 3 <123
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO4.COM Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums

DISCO4.COM is independent and not affiliated to Land Rover.
Switch to Mobile Site