stevev6
Member Since: 31 Aug 2007
Location: gloucester
Posts: 21
|
fitting of land rover lamps to A bar |
|
has anybody any tips for the fitting of land rover lamps to the A bar /how easy is it to do the complete job
|
1st Oct 2007 7:32 pm |
|
|
craig
Member Since: 08 Aug 2006
Location: Home of LR.
Posts: 2545
|
Just done it.
TBH the instructions are OK for about 75% of the time. I had difficulty with finding the negative terminals for power (between the FBH and the battery box) and also with getting the CJB off and getting the single wire to connect into the CJB (undo the nut just to the right of the CJB which gives you the required finger space, to get behind it, and find the catch)
As i found out through the experts on this forum you will need to get your dealer to activate them (your spots)on there IDS terminal, or you can put a PM through to 10forcash who will be willing to do this activation and install as well i guess for some beer tokens....
Also (final tip) where the instructions say to use the body bonding points in the footwell of the passenger side, which is a bit tight on the wire, you can use the bonding points in the drivers side...
|
1st Oct 2007 7:52 pm |
|
|