Member Since: 01 May 2019
Location: Nice
Posts: 88
Parts identification - help needed
Hi Guys,
Your help would be appreciated in identifying below parts - disclaimer - I did go through workshop manual and could not find enough info to be able to order what would be needed.
Thank you in advance!
1. Where to attach this pipe (and if any other there on pics), what parts are needed? (first three pics showing pipe from under the car).
Click image to enlarge
Click image to enlarge
Click image to enlarge
2. What is this? (sensor?) What's needed and where it should be attached? It is loose at the moment. It's on some sort of relatively hard tube though a bit flexible. (red circled, close to engine cooling tank).
Click image to enlarge
Click image to enlarge
3. Just fixings missing - what are part number for these? Again, can't find it (just probably missing the keywords or something - did my search already and feel dumb that couldn't find it - hence help needed).
These two tubes are part of upper hoses and are on top of compressor. The black portion is air chamber
Click image to enlarge
Click image to enlarge
4. Need to identify what this socket/plug was for, I'd like to replace it and get it fixed. Nothing is missing/disconnected or the mechanic did not connect it. It is behind right headlamp (headlamp removed on pics).
Click image to enlarge
Click image to enlarge
5. Grill fixing points missing - this one I had already ordered. What came is too large, doesn't fit into the metal frame (this frame is from LR3 not LR4 post-lift - it shouldn't matter though maybe this is the little detail where it matters. Need to put LR4 post-lift grill there. The grill itself fits fine, just small rubber/plastic elements are missing so the grill would not rattle.).
Click image to enlarge
Thanks again for help!
27th Mar 2024 9:07 am
Biffysun
Member Since: 09 Jul 2011
Location: Central
Posts: 1787
The 'sensor' as shown in pics 4 & 5 of your post is the front diff breather tube and thats how it should be
27th Mar 2024 9:20 am
lrovy
Member Since: 01 May 2019
Location: Nice
Posts: 88
Thanks! It's loose though and can rattle (I don't believe there should be anything loose in the engine bay - it has to be attache somewhere, right?)
27th Mar 2024 9:24 am
Biffysun
Member Since: 09 Jul 2011
Location: Central
Posts: 1787
can't think off hand as I no longer have a D4, but if its rattling you could use a cable tie or re route slightly, sorry can't be any more specific
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
can't think off hand as I no longer have a D4, but if its rattling you could use a cable tie or re route slightly, sorry can't be any more specific 
