LIAMMCL
Member Since: 27 Aug 2013
Location: Northumberland
Posts: 407
|
Land Rover wire terminals |
|
I swapped the rear PDC loom this weekend not knowing there are 2 kinds. I'm assuming that due to mine being an early D4 it has the boots keyless antenna set into to rear pdc loom, the antenna sits in a recess in the polystyrene part of the bumper and plugs into the pdc loom.
In the new looms connector, the 2 terminal positions for the keyless antenna are blanked off so I'm going to attempt to remove the wires from the old connector and refit the antenna (keyless currently not working for the boot lid).
I've tried paperclips and small screwdrivers etc. trying to find the burr that holds the terminals into the connector and I'm going to end up damaging them.
So A) how do you remove the terminals? /or/ B) where can you buy new ones?
Thanks in advance
|
12th Feb 2018 11:00 am |
|
|
LIAMMCL
Member Since: 27 Aug 2013
Location: Northumberland
Posts: 407
|
I've worked out the white 'bezel' needs to be released then the plastic catches can be lifted.
I've plugged the antenna loom back in to the new connector(stuck the antenna behind the tail light with double sided number plate tape) and all is working as should be. I'll put it back in the proper place if the bumper ever comes off again but its fine for the moment.
|
12th Feb 2018 2:41 pm |
|
|