I hate to put up a new post for this but I can't seem to find an answer. Does anyone know what type of nuts I am suppose to put on new copper turbo studs LYR500010. Flange or not ? Copper or not ? Washer or not ?
Take out the studs and drill the threads out to 8mm. Use 2 x M8 flange bolts to refit. This aids future turbo removal massively, and is also much quicker.
Do NOT rely on this without confirmation with more knowledge than I. This comes from a not I made some years ago.
NJSSAm I Gammon or Woke ? - I neither know nor care.
2016 Discovery 4 Landmark
2011 Mercedes Benz SL350 (R230)
1973 MG B GT V8 - 3.9L John Eales engine, 5 speed R380 gearbox, since 1975.
1959 MGA roadster - 1.9L Peter Burgess Engine - 5 speed gearbox
Past LRs - Multiple FFRs, Discos & a Series I - some petrol, some diesel,
none Electric or H2 fuel cell - yet.
There are 10 types of people in this world: Those who understand binary, and those who don’t.
19th May 2022 3:36 pm
SteveNorman
Member Since: 14 Oct 2005
Location: Somerset
Posts: 1144
Correct part number is : LR025680
A flanged nut which I think is copper.
The older part number: WYH500020 was flanged steel
regards
Steve
19th May 2022 3:54 pm
Dave InOz
Member Since: 29 Jun 2016
Location: NSW
Posts: 37
NJSS wrote:
Quote:
Take out the studs and drill the threads out to 8mm. Use 2 x M8 flange bolts to refit. This aids future turbo removal massively, and is also much quicker.
Do NOT rely on this without confirmation with more knowledge than I. This comes from a not I made some years ago.
NJSS
The Stud is already 10mm so I don't think it applies.
20th May 2022 1:22 am
Dave InOz
Member Since: 29 Jun 2016
Location: NSW
Posts: 37
SteveNorman wrote:
Correct part number is : LR025680
A flanged nut which I think is copper.
The older part number: WYH500020 was flanged steel
regards
Steve
Thanks Steve
The only reference off technical drawings I could find was HN1
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum