Advertise on DISCO4.COM
Forum · Gallery · Wiki · Shop · Sponsors
DISCO4.COM > Camping, Caravanning and Holidays

Trims heating ...heeelllppp
Post Reply  Down to end
Page 1 of 1
nearlee
 


Member Since: 15 Dec 2012
Location: where the sheep are scared
Posts: 1777

Wales 2005 Discovery 3 TDV6 S Auto Bonatti GreyDiscovery 3
Trims heating ...heeelllppp

Since me and electrics shouldn't mix can someone spot anything obvious in the picture that seems wrong?
It is the control box that sits on the back of the truma heater in my wobble box.

 Just remember:-
Amateurs built the Ark
Professionals built the titanic 
 
Post #188124219th Nov 2017 3:52 pm
View user's profile Send private message View poster's gallery Reply with quote
Sea Raider
 


Member Since: 01 Nov 2016
Location: None
Posts: 4450


Looks like a bit of burning - is that a relay? I'm on my phone and can't really see it without my spex

  
Post #188124919th Nov 2017 4:00 pm
View user's profile Send private message View poster's gallery Reply with quote
nearlee
 


Member Since: 15 Dec 2012
Location: where the sheep are scared
Posts: 1777

Wales 2005 Discovery 3 TDV6 S Auto Bonatti GreyDiscovery 3

It's relay sized, but seems fixed to the board.
 Just remember:-
Amateurs built the Ark
Professionals built the titanic 
 
Post #188125819th Nov 2017 4:17 pm
View user's profile Send private message View poster's gallery Reply with quote
Leon
 


Member Since: 26 Apr 2014
Location: Leamington Spa
Posts: 424

England 2005 Discovery 3 TDV6 Base 7 Seat Manual Zambezi SilverDiscovery 3

Looks like a transformer.
  
Post #188126119th Nov 2017 4:20 pm
View user's profile Send private message View poster's gallery Reply with quote
nearlee
 


Member Since: 15 Dec 2012
Location: where the sheep are scared
Posts: 1777

Wales 2005 Discovery 3 TDV6 S Auto Bonatti GreyDiscovery 3

I'm assuming then it shouldn't be brown on top?
Also assuming this could be the cause of the electric heating not working?
 Just remember:-
Amateurs built the Ark
Professionals built the titanic 
 
Post #188127019th Nov 2017 4:36 pm
View user's profile Send private message View poster's gallery Reply with quote
Leon
 


Member Since: 26 Apr 2014
Location: Leamington Spa
Posts: 424

England 2005 Discovery 3 TDV6 Base 7 Seat Manual Zambezi SilverDiscovery 3

Without testing couldn't say, the over-temp and temp stats tend to fail quite often, they are on the element side and are circular silver disks.

When testing they should have continuity between the two terminals.

Ours failed on our van-they physically looked ok but no continuity between the pins. When I tried to remove them they fell apart.

Fitted new ones and all ok.
  
Post #188128219th Nov 2017 5:01 pm
View user's profile Send private message View poster's gallery Reply with quote
nearlee
 


Member Since: 15 Dec 2012
Location: where the sheep are scared
Posts: 1777

Wales 2005 Discovery 3 TDV6 S Auto Bonatti GreyDiscovery 3

I assume I need to strip fire down to get to the heater element to check the over temp and temp stats?
 Just remember:-
Amateurs built the Ark
Professionals built the titanic 
 
Post #188128619th Nov 2017 5:20 pm
View user's profile Send private message View poster's gallery Reply with quote
UNG
 


Member Since: 20 Jun 2008
Location: Lancs
Posts: 753

United Kingdom 

Looks like a transformer that has burnt the problem is locating the fault that has caused it to overheat
 "Never keep up with the Joneses. Drag'em down to your level. It's cheaper".  
Post #188130519th Nov 2017 6:02 pm
View user's profile Send private message View poster's gallery Reply with quote
Leon
 


Member Since: 26 Apr 2014
Location: Leamington Spa
Posts: 424

England 2005 Discovery 3 TDV6 Base 7 Seat Manual Zambezi SilverDiscovery 3

Two of the cables that go from the pcb to the front of the fire go to the over-temp stat and the temp stat (wired in series)but for the life of me can't remember the colours. Might be worth ringing truma and asking them to save you taking the fire out(Truma Tec support are really helpful), you can then test at the pcb end by taking the wires out of the pcb connector and testing on the wires.
  
Post #188130819th Nov 2017 6:10 pm
View user's profile Send private message View poster's gallery Reply with quote
nearlee
 


Member Since: 15 Dec 2012
Location: where the sheep are scared
Posts: 1777

Wales 2005 Discovery 3 TDV6 S Auto Bonatti GreyDiscovery 3

Guys thank you very much for the help and pointers, something to get stuck into
 Just remember:-
Amateurs built the Ark
Professionals built the titanic 
 
Post #188135019th Nov 2017 7:27 pm
View user's profile Send private message View poster's gallery Reply with quote
nearlee
 


Member Since: 15 Dec 2012
Location: where the sheep are scared
Posts: 1777

Wales 2005 Discovery 3 TDV6 S Auto Bonatti GreyDiscovery 3

Just to close this, got a new pcb board and heating is now working fine.

Thanks for the pointers folkes
 Just remember:-
Amateurs built the Ark
Professionals built the titanic 
 
Post #191578117th Feb 2018 6:04 pm
View user's profile Send private message View poster's gallery Reply with quote
Leon
 


Member Since: 26 Apr 2014
Location: Leamington Spa
Posts: 424

England 2005 Discovery 3 TDV6 Base 7 Seat Manual Zambezi SilverDiscovery 3

Thumbs Up
  
Post #191579417th Feb 2018 6:20 pm
View user's profile Send private message View poster's gallery Post Reply
Display posts from the last:  
Post Reply Back to top
Page 1 of 1
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO4.COM Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums

DISCO4.COM is independent and not affiliated to Land Rover.
Switch to Mobile Site