Member Since: 03 Jun 2014
Location: Christchurch
Posts: 1125
Xenon lights fitted to Discovery 4 MY12 GS
Successfully fitted my new Xenons to my Disco4 today
So now I have my next problem.... The full beam light needs a new white light halogen to be fitted so it doesn't look yellow up against the Xenons. I can't figure out for the life of me how to get the main beam bulb out... Any pointers?
Otherwise, the Xenons are a massive improvement and using the fairy lights as DRLs switched to sidelight position is a bit posey, but feels nice to see them reflect back in the rear of the car in front
Member Since: 08 Mar 2010
Location: Warwickshire
Posts: 1477
With the headlight removed don't you remove the smaller of the two caps on the back then you can see the bulb. Pull the wiring connector off the bulb and unhook the spring clip from round the bulb one side at a time?
21st Aug 2014 1:48 am
Parallax33
Member Since: 03 Jun 2014
Location: Christchurch
Posts: 1125
Nah, it's not like the dipped beam clip. Some kind of top hat with what looks like an integral spring arrangement... From the manual it just looks like you unclip each side. I will try again later...Justin
Member Since: 08 Mar 2010
Location: Warwickshire
Posts: 1477
Really? I don't remember it being difficult or unusual (although its been a while), you are sure you aren't trying to remove the xenon bulb aren't you?
21st Aug 2014 11:36 am
Parallax33
Member Since: 03 Jun 2014
Location: Christchurch
Posts: 1125
Member Since: 08 Mar 2010
Location: Warwickshire
Posts: 1477
Right so at least we know you are in the right hole
Presume you have pulled the cable connector off the bulb?
The square thing you see in the pic is what I assume you mean by the top hat thing? This doesn't come off its attached to the lamp unit the bulb rests on it held in by the clip.
I was worried by what you said in earlier post that the clip wasn't like the one on dipped beam bulb - you were referring to your previous halogens weren't you as the dipped bulb in a xenon also works as main beam (with the use of a shutter), the bulb you want to change is referred to in the manual as the main beam fill in lamp.
21st Aug 2014 5:26 pm
Parallax33
Member Since: 03 Jun 2014
Location: Christchurch
Posts: 1125
Yep that's the cookie!
I will give it a go tomorrow night... Away tonightJustin
Member Since: 01 Oct 2011
Location: Chester
Posts: 140
Ive just ordered these, how come the full beam light is more orange than the dip?
22nd Aug 2014 12:48 pm
discoteca
Member Since: 08 Mar 2010
Location: Warwickshire
Posts: 1477
Because the xenon bulb (white, outer) works as dipped and main beam (by the use of a mechanical shutter to cover part of the bulb for dipped operation). The other bulb (inner, which you call the main beam bulb) is actually called high beam fill in bulb on xenon lights and supplements the operation of the xenon bulb on main beam. It is also used for the headlight flash function. This bulb remains a halogen bulb (more yellow than white) even in the xenon headlamps.
In the halogen headlamps the outer bulb is dipped the inner bulb is main beam.
22nd Aug 2014 2:49 pm
munders
Member Since: 23 Jul 2014
Location: marlborough
Posts: 55
bulb
Hi, all
Just wanted to know did any one find out which main beam bulb to change to from the yellow lloking one in the xenon headlight configuration!!!!!!
What whiter bulb is used?
Cheers
24th Aug 2014 9:24 pm
Parallax33
Member Since: 03 Jun 2014
Location: Christchurch
Posts: 1125
Lol, SWMBO has kept me busy this weekend. Hope to get round to
Answering this tomorrow evening Justin
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
