Member Since: 24 May 2010
Location: suffolk
Posts: 25
Suspension won't raise
Hi all,
My D3 suspension is refusing to raise. The compressor is silent but if I run an independent 12v supply direct to it, it runs but car still won't rise. Have tested the relay and all associated fuses.
Fault codes are:- B1B02-28 low frequency coil - general signal failure. B1C57-14 passive start ignition relay coil circuit - general electrical failure. C1A36-01 exhaust valve - general electrical failure.
Am I right in saying that the Exhaust valve is part of the compressor assembly ?
Anyone got any ideas on what to test or look for ?
TIA.
15th Nov 2023 9:27 pm
loanrangie
Member Since: 18 Jun 2017
Location: Melbourne
Posts: 609
yep your up for a new exhaust valve, may as well service compressor at the same time.
16th Nov 2023 1:37 am
Sidestick
Member Since: 22 Apr 2012
Location: Rome
Posts: 2288
from memory, the exhaust valve is commanded from the pilot exhaust valve which get pressure from the silica bottle and is commanded via a solenoid. Usually if silica are aged they become like sand clogging air valves pilot exhaust included.
I will start checking silica bottle - Easy-Lift suspension module 4.0
- GoodWinch 9500 lb
- Full underbody protections
- Tree/Rock sidebars
- Prospeed roofrack & ladder
- Compressor guard
- Raised Air Intake
- Driving lights (2+4)
- 50 mm Waffle boards
- Altox Heater control
- Overland Rooftop Tent
- Rear seats entertainment
- Front & Rear camera
- GVIF
- Removable tow bar
- Cubby box fridge
- BFG KO2 265/65R17
- iidTool BT
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum