Member Since: 25 Mar 2017
Location: LINCOLN
Posts: 2
EPB lost communications - Resolved
Discovery 3 . Handbrake not working at all.. No communication with diagnostics all other modules showing lost communications with epb module.
After much searching I found an earth splice, corroded so badly that both earths from the epb module had rotted off, in the loom just to left of the epb as viewed from the rear.
26th Mar 2017 8:55 pm
Disco_Mikey
Member Since: 29 May 2007
Location: Dundee, Scotland
Posts: 20732
Member Since: 22 Dec 2013
Location: Newcastle
Posts: 210
Can someone please explain where this is in the harness? Such as spare wheel space 50mm from box section etc.
Thanks
Rich
4th Jul 2019 9:31 am
Jim66a
Member Since: 25 Mar 2017
Location: LINCOLN
Posts: 2
Hi Rich, The break was in the +12v cable (green/yellow) where it splits from a single to the two +12v cables (both green/yellow) to the handbrake unit.
This splice is on the passenger side by the rear wheel. I followed the g/y wired back from the handbrake unit pulling them out of the plastic sheathing. It was tricky to reach and I used the low temp solder / heat shrink connectors.
Hope that helps.
Regards Jim
6th Jul 2019 8:52 am
AL_P
Member Since: 17 Feb 2017
Location: London
Posts: 161
Hi
Think I may have the same problem but can’t locate the join.
Is it the one that sits behind the suspension strut but above the cross member making it a real pain to get to?BT Gap IID
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum