Member Since: 31 Aug 2015
Location: Essex
Posts: 828
Removing foam case for standard scissor jack
I have got myself a small bottle Jack and had planned to store it where the standard Jack goes. But I'm struggling to get the piece of foam out that the scissor Jack sits in. I don't want to ruin it, because it may be put back in at some point. I just can't figure out what's holding it in - any tips?MY2012 D4 HSE Nara Bronze with some extra stuff
2nd Jan 2018 3:10 pm
Top-Trucker
Member Since: 27 Mar 2013
Location: yorkshire
Posts: 37
From memory it just pulls out, maybe with a little squeeze and persuasion16ltr V8 600hp - gone
90td hard top - gone
D3 HSE
As one door shuts another one gets slammed in your face!
2nd Jan 2018 3:17 pm
LaserTam
Member Since: 31 Aug 2015
Location: Essex
Posts: 828
ok thanks. Didn't want to 'persuade' it too much for obvious reasons, will give a bit more of a pull.MY2012 D4 HSE Nara Bronze with some extra stuff
2nd Jan 2018 7:35 pm
Tanglewood
Member Since: 27 Feb 2011
Location: Wilts
Posts: 1376
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum