Member Since: 13 Apr 2018
Location: Weymouth
Posts: 261
2016 Disco 4 - A Pillar Trim Clips
Does anyone know in what position on the A Pillar trim the white clips goes.
As I understand it the trim clip kits come with 4 grey clips and one white for each trim.
On my nearside A pillar the trim is loose at the top and lifting it away from the car I can see the white clip in there that is not "clipping" into position.Gone 2016 Landmark D4
Current 2015 HSE D4 - AKA - 'Gandalf the Grey'
The earlier sets would have yellow and white clips, white clip at the very bottom followed upwards with yellow. If they have popped off replace them, it is I fit once and replace.
17th Nov 2018 11:01 am
Weyboat
Member Since: 13 Apr 2018
Location: Weymouth
Posts: 261
Thanks for that info.
National Windscreens have fitted the white one at the top hence the reason why the trim is loose at the top!
When I queried this with the local depot manager he tried to tell me that the white one goes at the top and the grey ones go beneath it...Gone 2016 Landmark D4
Current 2015 HSE D4 - AKA - 'Gandalf the Grey'
I did post the section direct from Topix in one of the screen posts stating the correct order. AW couldn’t get mine correct put the white ones in position two and three on one side and yellows in all other positions.
17th Nov 2018 6:17 pm
MrBrain
Member Since: 12 Mar 2014
Location: bucks
Posts: 471
We have just refitted mine and had to use yellow ones all the way down as the white clip would not go home.
17th Nov 2018 6:44 pm
Weyboat
Member Since: 13 Apr 2018
Location: Weymouth
Posts: 261
Found a useful diagram that has some text explaining the bottom clip
Gone 2016 Landmark D4
Current 2015 HSE D4 - AKA - 'Gandalf the Grey'
17th Nov 2018 9:35 pm
JPW
Member Since: 19 Mar 2007
Location: Essex
Posts: 217
I've just bought a complete set of 5 clips from a Dealer - LR077843 - they are all identical and all grey. Have LR changed the design so that it doesn’t matter which clips go where (to make it easier for the “technicians” to get it right)?
Exterior Trim and Ornamentation - A-Pillar Moulding LH
Removal and Installation
Removal
• NOTE: This procedure is also applicable for the RH moulding.
1. Open the bonnet.
2. Remove the A-pillar moulding.
Release and discard the 5 clips.
Installation
1. NOTE: The lower clip is unique to the others and must only be installed to the lowest position on the moulding.
To install, reverse the removal procedure. 1. New clips must be used.
The pack of clips supplied from the dealer consisted of,
4 x yellow
1 x White
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum