Hello,
I'm working on replacing the rear brake lines. They were replaced once already by the dealer about 8 years ago (previous owner). When I look at the ABS module it looks like I've been driving all this time with the lines hooked up wrong. In the picture below the green lines go to the front wheels. The grey lines are the "newer" dealer installed replacements that run to the rear.
The labels on the ABS module are (left to right):
RL
RR
FR
FL
Which I would take to mean
RL - Rear Left
RR - Rear Right
FR - Front Right
FL - Front Left
When I look at the manual that seems to go with the description. Can anyone confirm?
Thanks!
Click image to enlarge
2006 SE 4.0 V6 with rear locker
21st May 2022 6:08 pm
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10372
Yeap it does seam wrong.
And that won’t work well when the abs engauges.
21st May 2022 6:44 pm
Disco_Mikey
Member Since: 29 May 2007
Location: Dundee, Scotland
Posts: 20733
What makes you suspect they're connected incorrectly, other than 2 pipes are green and 2 are silver?My D3 Build Thread
OK got it sorted. Turns out it was correct. One of the "new" lines was actually a new line to the front right. One of the new lines from the rear terminated at a junction block on the firewall, and had the old green line from the junction block to the ABS module. The other new line from the rear bypassed the junction block and ran straight to the ABS module. I had thought both the new lines going into the ABS module were from the rear. So now everything seems to be going to the correctly labeled port. Now to see if I can get the bubble flare made... thanks for looking.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum